Danby DDW631SDB Manuel du propriétaire télécharger pdf (Page 13)

CARE & MAINTENANCE

• Unplug the appliance from the power source

before completing any cleaning or maintenance.

• After every wash, turn off the water supply and

leave the door slightly open so that moisture and

odors are not trapped inside the appliance.

• Only use a soft cloth and mild detergent to

clean the appliance. Never use solvents or

abrasive cleaning agents as this can damage

the appliance.

• To remove water spots from the interior of the

appliance, use a soft cloth dampened with a

small amount of vinegar.

• If the appliance will not be used for a long

period of time, it is recommended to run a

normal wash cycle with the dishwasher empty

and then leave the door open until the interior

of the appliance is completely dry. This will help

the door seals last longer and will help prevent

odors from forming inside the appliance.

• Clean the door seals with a damp sponge

regularly to prevent odors from food particles

that can become trapped in the door seal.

E1: Not enough water getting into the unit

• The water source is not turned on

• Water intake is restricted

• Water pressure is too low

E3: Not reaching correct temperature

• Malfunction of heating element

E4: Water overﬂ ow

• Drain malfunction

• Drain clog

Ed: Control board malfunction

• Internal communication error

If the appliance displays any error code, a power

reset may resolve the issue. Unplug the appliance,

wait approximately 5 minutes and then plug the unit

back in.

CLEANING ERROR CODES

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 43 44

Pas de commentaire

Danby DDW631SDB Manuel du propriétaire Page 13